AgDealer Equipment # 685996
Location: Killarney 2015, Stock # K0647A, * Minimum requirements are a starting: point only and should be increased based on operating conditions and other implements that are used with the drill. Maximum allowable hydraulic pressure lower than either 3000 psi (20.7 MPa) or factory settings for individual tractors.
1 US gpm (3.8 lpm) Case Drain oil flow,: VR Cart - 4.8 US gpm (18.1 lpm)
20 US gpm (75.7 lpm) @ 5000 fan RPM: hydraulic oil flow
Additional 1.25 US gpm (4.7 lpm) per: meter required for variable rate meter drives
Category IV tractor drawbar that can: be locked in a stationary position with an intermediate drawbar chain support.
Closed center or load sensing: hydraulic system for tractor required
Do not tow a loaded air system while: transporting the implement between fields.
Do not tow more than two implements: behind the tractor while transporting between fields.
Do not tow the implement at speeds: over 20 mph (32 kmph)
Electrical system capable of 7 amp: nominal, 19 amp peak current draw (VR Cart - 4.0 amp nominal/peak)
Maximum Case Drain Pressure must: be less than 25 psi (172 kPa)
One hydraulic control valve for fan: and auger
Optional:: Variable - hydraulically driven mechanism with control from cab
The total towed weight should be: reduced based on tractor condition and road conditions.
The total towed weight should be less: than 1.5 times the maximumoperating
FBC Communications reserves the right to take legal action to enforce its intellectual property rights. Permission to copy any content on this website must be obtained from the copyright owner. For further information, or to request permission to republish, please contact [email protected]. Credits